Plainsnet Internet Support - Plainsnet - High-Speed Broadband Internet for Hughes and Garvin Counties in Rural Oklahoma

Go to content

Main menu:

Plainsnet Internet Support

Service and Support > Support
Hammer and wrench.

The steps below are meant to be a general first response to troubleshooting your internet connection. To the left of this article I intend to post troubleshooting guides for more specific problems later.

1. If you have a router, unplug the power to your router so that all the lights turn off on it, then wait for about thirty seconds before plugging it back in, then wait for another thirty seconds for it to fully boot. Try the internet.

2. Still not working? On the back of your router or computer, find our cable. It will be a short, three-inch black cable ending in a little box, with another cable connected to that box. Unplug the cable from that little box, then plug it back in; this resets our equipment. Wait for about thirty seconds to one minute, then try the internet again.

3. Still not working? If you have a router, ensure the short three-inch black cable is plugged into the "Internet" or "WAN" port on the back of your router. There should be 5 ports on the back of your router, and 1 one of them should be separate from the other 4; that one is the internet port.

4. Still not working? If you have a router, bypass the router by taking that short three-inch black cable from your router and plugging it into your computer instead (ensure the other cable is still plugged into the little box after you connect it to your computer).

5. Feel free to contact us or fill out our service request form at any time.

Back to content | Back to main menu